1/3 wall has same vehicle collision as full wall.

Discussion in 'Closed bugs' started by Herbie, Aug 13, 2016.

  1. Herbie

    Herbie Junior Member

    Messages:
    104
    Likes Received:
    8
    Trophy Points:
    0
    1. place 1 wall and a 1/3 wall piece
    2. drive a jeep onto the side with the 1/3

    There is an invisible wall that blocks vehicles which is very annoying.
     
  2. Smithy

    Smithy Developer Staff Member Administrator

    Messages:
    333
    Likes Received:
    68
    Trophy Points:
    0
    Just copying this over from the other thread.
     
  3. blizzerd

    blizzerd Member

    Messages:
    10,551
    Likes Received:
    60
    Trophy Points:
    0
    Isnt this bug known since forever? ive personally reported it to beerdude if i recall correctly.
     
  4. Tama

    Tama Developer Staff Member Web Developer

    Messages:
    684
    Likes Received:
    74
    Trophy Points:
    0
    No, this bug was not present in 2.8.0.

    Smithy and I are currently finishing up a fix - it has also uncovered a seperate issue, that we're not optimizing all our models for vehicle collisions.

    Also, now that I know how this system works, it seems I can fix another annoyance I have, that it is difficult to drive up the BE repair pad - we can make the vehicle collisions more leniant so that you can drive in at an angle :). That's for later though.
     
  5. Tama

    Tama Developer Staff Member Web Developer

    Messages:
    684
    Likes Received:
    74
    Trophy Points:
    0
    fixed in 2.9.2
     

Share This Page